WAGO

The input module connects directly to Pt resistance sensors. The connection of 2 or 3 conductor sensors is possible. The module automatically linearizes the entire temperature range. A sensor error is indicated by a red LED. A green LED indicate ...

This digital output module transmits control signals from the automation device to the connected actuators. All outputs are short-circuit-protected. Field and system levels are electrically isolated.

The analog input module processes signals of a standard magnitude 0–10V. The input signal is electrically isolated and is transmitted with a resolution of 12 bits. The internal system supply powers the module. The input channels of the module have one com

This fieldbus coupler allows connection of the WAGO I / O SYSTEM as a slave to the MODBUS or fieldbus. The bus coupler recognizes all connected I / O modules and creates a local process image on this basis. Analog and specialty module data is sent via wor

The input module connects directly to Pt resistance sensors.

After the fieldbus node is assembled with the correct bus coupler and I / O modules, the end module is snapped onto the assembly. It completes the internal data circuit and ensures correct data flow.

A connected actuator or load is switched via the relay output module. The 24 VDC supply is derived from the power jumper contacts to trigger the relays. The switched status of the relay is shown by the manual switch (1/0). The operating mode can be set us

The coupler module for the internal data bus extension module 750-628 replaces the fieldbus coupler / controller at an I / O terminal block. It is also the mating piece for the end module 750-627. Plug the connecting cable into the top RJ-45 socket to est

The counter is used for frequency measurement here, with the pulse period of the 24V signal being measured at the CLOCK input and then converted to a frequency value. Measurement is enabled and inhibited via the GATE input. Digital outputs DO 1 and DO 2 c

The analog input module processes signals of a standard magnitude 0–10V. The input signal is electrically isolated and is transmitted with a resolution of 12 bits. The internal system supply powers the module. The input channels of the module have one com

This digital output module transmits control signals from the automation device to the connected actuators. The internal system voltage triggers the relay. The NO contacts are electrically isolated. The switched status of the relay is shown by a LED.

The analog output module creates a standardized signal or 0-20mA or4-20mA.The output signal is electrically isolated and will be transmitted with a resolution of 12 bits. € œCurrent € œ analog output modules use power derived from the field side (lo ...

WAGO Parus M30 PRO Mini-farm kweeklamp

The end module for the internal data bus extension 750-627 is attached to the end of the I / O terminal block like the standard end module 750-600. The block is terminated with the module, to which a connecting cable can be attached with an RJ-45 connecto

The internal system supply module increases the current supply for the internal system by 2A. If the internal current consumption of all modules is higher than 2A, an additional supply module must be added. The module also supplies field side power to the

The internal system supply module increases the current supply for the internal system by 2A. If the internal current consumption of all modules is higher than 2A, an additional supply module must be added. The module also supplies field side power to the

The analog output module generates signals of a standard magnitude ± 10V. The output signal is electrically isolated and transmitted with a resolution of 12 bits. The internal system supply powers the module. The output channels or the module have a commo

The analog input module processes signals of a standard magnitude 4–20mA. The input signal is electrically isolated and is transmitted with a resolution of 12 bits. The internal system supply powers the module. The input channels of the module have one co